FLOPLAST 40mm (43mm) Waste Pipe Fitting to Overflow Reducer - Pack of 2

Product Information

The 14° White Soil Pan Connector for use when replacing an angled outlet pan with a horizontal outlet pan to 110mm soil systems. Solvent weld fit runs have the most extended lifespan of all waste systems, including push-fit and compression systems. If you would like to change your settings or withdraw consent at any time, the link to do so is in our privacy policy accessible from our home page. Some of our partners may process your data as a part of their legitimate business interest without asking for consent. To view the purposes they believe they have legitimate interest for, or to object to this data processing use the vendor list link below.

FloPlast Push-Fit Reducer White 40mm x 32mm - Screwfix FloPlast Push-Fit Reducer White 40mm x 32mm - Screwfix

In contrast, waste pipe fittings made from polypropylene and polyethene will not break down or bond when exposed to solvents.I couldn't find anything on the specification that stated whether it came down to 40mm, but if that's the one, then thanks very much for your advice. We and our partners use data for Personalised ads and content, ad and content measurement, audience insights and product development. quote="plumbbob"]There are one or two odd sizes of pipe about, and solvent weld is usually larger than std 40mm.

43mm Solvent Weld to 40mm Compression | DIYnot Forums 43mm Solvent Weld to 40mm Compression | DIYnot Forums

Stretched out under the bath trying to stretch the rubber washer over the pipe didn't seem 'easy' hence I didn't want to stretch it too far and find out I should have done it some other way. My outside waste pipe from the kitchen sink has a 90degree joint that has cracked and causing the waste to leak before reaching the main drain.

The plumber fitted a new boss and pipe rununder the floor, surfacing underneath the bath, all in grey solvent weld pipe, which according to the 45 degree elbow (has stamped on it) is 43mm pipe. I naively thought a simple replacement would be suitable however since found that the joint is solvent weld and has an outside diameter of 43mm rather the standard 40mm. Pipe should come out of wall fairly easily, could use multifit joiner T28M inside to connect from old pipe to new 40mm pipe. Secondly, i just cannot find a standard 90 degree joint that has a suitable diameter of 43mm standard.